With the current lifestyle change, in order to beautify the city, but also to facilitate people who travel outside at night, know the road signs, so now there will be work on lighting projects, especially in some hotels, office buildings, big summer, and other places, Lighting projects are absolutely indispensable. So today China Led Flood Light Factory will share the common LED line lights in the outdoor, its installation method.
1. Wiring method
The general voltage of led line lamp is AC220V, DC12V, DC24V. Therefore, it is necessary to select a suitable switching power supply. The size of the power supply is determined according to the power and connection length of the LED light bar. It should be noted that DC12V and DC24V should not be connected to AC220V, otherwise the lamp beads will burn out. DC12V can not be connected to the DC24V control power supply; otherwise, the power will be more than doubled, and it is easy to burn out the lamp bead. AC220V lights can be directly connected to the mains. RGB colorful LED strips need to use the controller to achieve the changing effect, generally using 4 lines to distinguish between black, red, green and blue. The colorful light bars are generally common anodes, that is, one of the light bars is +12V connected to the black line, the other is the negative pole, and the RGB is connected to the corresponding red, green and blue interface or power line.
2. Connection distance
In general, the 3528 series of LED line lights, the connection distance of up to 20 meters, 5050 series of LED lights, the longest connection distance is 15 meters. If this connection distance is exceeded, the led line lamp is very prone to heat, which will affect the service life of the led line lamp during use. The RGB simple controller has a control range of 10 to 15 meters, and the remote controller has a control range of 15 to 20 meters and a maximum distance of 30 meters. If the connection distance of the led line light is long and the controller cannot control the long light strip, then a power amplifier is needed for the tapping. Therefore, it must be installed according to the manufacturer's requirements when installing.
information about Led Flood Light Factory : https://www.xiangruilight.com/